3407 Rose Ave.
Ocean, NJ USA
POSI-GATE™ PNEUMATIC OR HYDRAULIC
VALVE GATE CONTROLLERS
POSI-GATE™ Valve Gate Controllers are simple, effective and economical solutions for controlling the operation of single or double zone Pneumatic valve gated molds.
Due to its large capacity, the PG-10 is able of controlling from 1 to several Valve Gates simultaneously. Ease of operation, reliability and long life are the main design objectives of this unit.
In order to facilitate programming and set-up, the POSI-GATE™ is equipped with one timer to control the open time of the gate. The countdown timer also helps with visualization of the cycle stage at any one point. Timing accuracy is +/- 1ms.
The cycle can be initiated either by a micro-switch contact at the mold closing or by closing dry contacts of a relay at the injection molding press.
The PG-10 comes complete with all mating quick-disconnect couplings and 12’ cable with pre-wired connector at one end. Standard operating voltage is 110 VAC, or 220 VAC on request.
The PG-20 can be used to operate valve gates sequentially at two different times. Set-up of both units is straight-forward. Instructions are located on a label on the back of each unit.
PG-10 Single Zone
PG-20 Double Zone
PG-40 Four Zone
REQUEST A QUOTE
Your email address will remain confidential.
We will contact you with pricing and delivery information as soon as we receive your email.